Table of Contents
Advertisement
Parameter
Display
Suspend
Timeout
Auto Power-Off
Timeout
Remote Host
Power Control
Power On After
Power Loss
Enable Wake-
on-USB
Enable Wake-
on-LAN
© 2020 Teradici
Description
Configure the number of seconds to wait after a period of inactivity (that is, no keyboard or
mouse action) before the client puts its attached displays into low power mode. Valid values are
10 to 14400 seconds, or use 0 to disable the feature.
This timeout only applies when the device is in session.
When connected to a workstation, this feature requires
enabled.
Configure the number of seconds to wait after a period of inactivity (that is, no keyboard or
mouse action) before the client powers down. Valid values are 60 to 28800 seconds, or use 0 to
disable the power down.
Non-zero values are only enabled when the PCoIP client supports powering off.
This timeout only applies when the device is not in session.
Configure the client's remote power setting.
Select from the following options:
• .Power-off not permitted: Users cannot remotely shut down the host PC from the Tera2 PCoIP
Zero Client. When this option is selected, the
appear when the PCoIP Zero Client's connect/disconnect button is pressed.
• Hard Power-off only: Users are able to remotely shut down the host from the Tera2 PCoIP
Zero Client. When this option is selected, the
when the Tera2 PCoIP Zero Client's connect/disconnect button is pressed.
When enabled, the client automatically powers back on when power is supplied.
When enabled, configures the client to power up when the user presses a key on the keyboard.
Wake-on-USB applies when the client is either powered off automatically or as a result of the
user holding down the power button.
Clicking or moving the mouse will not power up the client when this feature is enabled.
When enabled, configures the client to wake up from a low power state when it receives Wake-
on-LAN magic packets.
AWI: Power Permissions
Zero Client Control Panel
Zero Client Control Panel
Local Mouse and Keyboard
on the OSD does not
on the OSD appears
to be
312
Advertisement
Table of Contents
