Table of Contents
Advertisement
To import the certificates to a device using the AWI:
1. From a browser, log into the AWI for the Tera2 PCoIP Zero Client or PCoIP Remote
Workstation Card.
2. From the AWI, select Upload > Certificate.
3. Upload both the Root CA certificate and the certificate with the private key, using the Browse
button to locate each certificate and the Upload button to upload them.
4. From the OSD or AWI, select Configuration > Network.
5. Select Enable 802.1x Security.
6. Click Choose beside the Client Certificate field.
7. Select the certificate with the private key, and then click Select.
8. Enter the identity name of the certificate. Typically, this is the universal principal name (UPN)
that appears after Subject: (for example,
Windows server may be configured to use the certificate's Subject, the Subject Alternative Name, or
another field
For the identity name, your Windows server may be configured to use the certificate's Subject, the Subject
Alternative Name, or another field. Check with your administrator.
9. To enable greater 802.1x compatibility for older switches on the network, select Enable 802.1X
Support for Legacy Switches. This setting is only available from the AWI Network page.
10. Click Apply, and then click Reset.
Getting more information about 802.1x
For more information about 802.1x, see the following Knowledge Base articles, available from the Teradici Support
Center:
•
Do PCoIP Zero Clients and PCoIP Remote Workstation Cards support network authentication or 802.1x? (KB
1357)
•
How to set up Windows Server 2008 R2 as an 802.1X Authentication Server (KB 1336)
•
PCoIP Troubleshooting Steps: IEEE 802.1x Network Authentication (KB 1088)
© 2020 Teradici
Import the Certificates to the Client Device
zeroclient@mydomain.local
).
352
Advertisement
Table of Contents
