Table of Contents
Advertisement
Parameter
Maximum Initial Image
Quality (AWI only)
Image Quality Preference
Maximum Frame Rate
(AWI only)
Disable Build to Lossless
(AWI only)
© 2020 Teradici
Configuring Image Quality
Description
Move the slider towards Reduced to reduce the network bandwidth peaks caused by
screen content changes, but produce lower quality images. Move the slider towards
Perception-Free to produce higher quality images but also higher bandwidth peaks.
This parameter limits the initial quality on the first display frame of a screen change.
Unchanged regions of the image are built to a lossless state regardless of this
parameter.
The Maximum Initial Image Quality must be greater than or equal to the Minimum Image
Quality.
Move the slider towards Smoother Motion to result in a higher frame rate at a lower
quality level. Move the slider towards Sharper Image to result in a lower frame rate at a
higher quality level. The range is from 0 to 100 in steps of 5.
This setting doesn't work in PCoIP sessions with VMware Horizon virtual desktops that run
release 5.0 or earlier.
The maximum frame rate helps you manage multiple PCoIP sessions over a single
network link. This setting determines the limit that your users can reach. Set this field
to 0 to set no frame limit. If you set a value, a single user is limited to that value. This
helps to control the user experience for all your users.
Clear this check box to retain the PCoIP protocol's build-to-lossless feature, where
images continue to be refined in the background until they reach a fully lossless state
(that is, identical pixel-for-pixel rendering when compared to the host image source).
This is the default (recommended) setting.
Warning: Selecting the Disable Build to Lossless check box degrades images.
Selecting the Disable Build to Lossless check box degrades the images presented to
the user. Don't select this check box unless your administrator decides that users
don't require optimal image quality to perform critical functions.
If you select this check box, the PCoIP protocol rapidly builds the client image to a
high quality image that may be perceptually lossless, but is not a fully lossless state.
This may provide some bandwidth savings, but is not recommended for use cases
that require images and desktop content to be truly lossless.
This setting does not work in PCoIP sessions with VMware Horizon virtual desktops that run
release 5.0 or earlier.
324
Advertisement
Table of Contents
