Table of Contents
Advertisement
Touch screen's co-ordinates are saved in flash memory
Once the touch screen is calibrated, the co-ordinates are saved in flash memory. You can manually recalibrate
the screen as required through the OSD Touch Screen page.
5. Follow the touch screen prompts. You can test the calibration with your finger (the cursor
should move with your finger). If the screen is not properly calibrated, the system
automatically restarts the calibration program.
Configuring the Touch Screen from the OSD
Setting
Enable right click on hold
Right click delay
Touch screen calibration (N/A; You must press Start
to begin calibration)
The OSD Touch Screen page, as shown next, enables you configure and calibrate settings for an
attached Elo TouchSystems touch screen display.
© 2020 Teradici
Configuring the Touch Screen from the OSD
Default
Disabled
Set for a shorter
delay
AWI
OSD
Management
Console
230
Advertisement
Table of Contents
