Enabling Syslog - Wacom Cintiq Pro 32 Manual

When you disable the event log, you won't be able to access logging options, all existing event logs
will be deleted, and logging will be disabled. If you've configured syslog settings, logs won't be sent
to the syslog server.
To enable the event log:
1. From the AWI, select Diagnostics > Event Log.
2. From the AWI Event Log page, select the Enable Event Log check box.
3. Click Apply.

Enabling Syslog

To configure syslog, you'll need to enable syslog, enter the IP address or Fully Qualified Domain
Name (FQDN) for the syslog server, and specify the port number and facility to use to send
messages to the syslog server.

Before you can enable syslog, you must enable the event log
Before you can access and configure syslog settings, you need to select the Enable Event Log check box (see
Event Log).

Syslog default values
Teradici uses UDP to send syslog messages to a centralized syslog server. Because most servers use port 514 for
incoming messages, Teradici recommends you configure port 514 (the default port number) as the syslog port.
However, you can use a different port as long as the syslog server receives the syslog messages on the same port
that the device sends the messages.
Teradici also uses 19 – local use 3 as the default facility because this facility isn't commonly used. If you use it, select a
different facility.

Facility values used by Cisco equipment
Cisco IOS devices, CatOS switches, and VPN 3000 concentrators use the 23 – local use 7 facility.
Cisco PIX firewalls use the 20 – local use 4 facility.
© 2020 Teradici
Enabling Syslog
Enabling
363