Table of Contents
Advertisement
Tested Smartcard Models
GSC-IS and PIV Authentication Flow
The default authentication flow prior to firmware 6.5 was to use the GSC-IS driver before the PIV driver. Now the PIV
driver is used first before the GSC-IS driver. If required, you can change the default authentication flow by enabling the
Prefer GSC-IS setting. See
When enabled, if a smart card (CAC) supports more than one interface such as GSC-IS and PIV then GSC-IS is used.
However in the case where the card supports both GSC-IS and PIV, and only PIV objects are configured on the card
then the connection may fail. If this is the case uncheck the box and retest. If a smart card supports only one
interface, such as either GSC-IS or PIV endpoint, then only the GSC-IS or PIV endpoint interface is used regardless of
this setting. This only affects smart card access performed outside of PCoIP sessions.
Tip: Viewing all columns of a table
Scroll to the bottom of the table and use the horizontal scroll bar to view all columns of large tables
Teradici has tested these specific smart card models:
Model
Cyberflex Access
64K V2c
ID-One Cosmo
v5.2D 64K
© 2020 Teradici
Tested Smartcard Models
advanced settings
for View Connection Server session type.
Specification
Middleware
and/or Applet
Provider
CAC (GSC-
ActivIdentity
IS)
ActivClient
v2.6.1
applet
CAC (GSC-
ActivIdentity
IS)
ActivClient
v2.6.1
applet
Pre-Session
In-
Authentication
Session
Use
3.2.0 and
3.2.0
higher
and
higher
3.2.0 and
3.2.0
higher
and
higher
Comments
Also referred to as
the Gemalto Access
64KV2 Note 2,3
Also referred to as
the Oberthur
Cosmo64 V5.2D
Note 2,3
426
Advertisement
Table of Contents
