Table of Contents
Advertisement
Configuring Display Override Settings
Under normal operation, the GPU in the host computer queries a monitor attached to the PCoIP
Zero Client to determine the monitor's capabilities. These are reported in the Extended Display
Identification Data (EDID) information. In some situations, a monitor may be connected to a client
in a way that prevents the client from reading the EDID information, such as when connecting
through certain devices, such as keyboards and mice. You can configure the Enable Attached Display
Override feature to enable the client to advertise default EDID information to the host's processor.
You can configure display override settings for a dual monitor or quad monitor setup.
Setting
Enable Attached Display Override
Enable Preferred Resolution Override
Enable Display Cloning
Setting not available
Display Cloning is not a supported feature on PCoIP Zero Client quad models (TERA2140).
From the OSD Display page, you can enable the Extended Display Identification Data (EDID)
override mode for a setup with two or four attached displays.
© 2020 Teradici
Configuring Display Override Settings
Default
1
AWI
OSD
(TERA2321)
(TERA2321)
Management Console
353
Advertisement
Table of Contents
