Wacom Cintiq Pro 32 Manual page 81

Parameter
Auto Connect
Remember
Username
Auto Launch If
Only One Pool
Use OSD Logo
for Login
Banner
Prefer GSC-IS
Enable Peer
Loss Overlay
© 2020 Teradici
OSD: View Connection Server Session Settings
Description
This field determines the client's auto connect behavior after startup:
Enabled: The client automatically connects with the connection server after startup and a PCoIP
session ends, bypassing the OSD Connect page.
Disabled: The client does not automatically connect with the connection server.
Enabled With Retry On Error: The client will continuously attempt to contact the connection server.
After a connection failure, the client waits before attempting to connect again. This wait time
increases with each successive failure. The wait interval is not configurable.
Devices running firmware 4.1.1 or lower do not support Retry On Error behavior and will always
perform a single attempt to contact the connection server when this option is selected.
After enabling Auto Connect, the client must be power-cycled for the change to take effect.
When enabled, the user name text box automatically populates with the last username entered.
When enabled, users are automatically connected to a provisioned desktop or application after
user credentials are entered.
This feature only applies to users who are entitled to a single desktop. It does not apply to users
entitled to multiple virtual desktops.
When enabled, the OSD logo banner appears at the top of login screens in place of the default
banner.
When enabled, if a smart card (CAC) supports more than one interface such as GSC-IS and PIV
then GSC-IS is used. However in the case where the card supports both GSC-IS and PIV, and only
PIV objects are configured on the card then the connection may fail. If this is the case uncheck
the box and retest. If a smart card supports only one interface, such as either GSC-IS or PIV
endpoint, then only the GSC-IS or PIV endpoint interface is used regardless of this setting. This
only affects smart card access performed outside of PCoIP sessions.
When enabled, the 'Network Connection Lost' overlay appears on the display(s) when a loss of
network connectivity is detected. Normal hypervisor scheduling delays can falsely trigger this
message.
Desktop applications that require the peer loss notification should re-enable the feature through
the OSD, AWI, or PCoIP Management Console.
81