Wacom Cintiq Pro 32 Manual page 229

Setting Up a Touch Screen Display
This topic explains how to install and configure an Elo TouchSystems touch screen display for
your Tera2 PCoIP Zero Client. You'll learn how to:
• Install an Elo TouchSystems touch screen display (see
• Configure and calibrate settings for an attached Elo TouchSystems touch screen display (see
Configuring the Touch Screen from the
• Configure the firmware if you want the touch screen to be controlled by a driver running on the
host (see Setting up the Touch Screen as a Bridged
• Set up auto-logon to bypass authentication when users are connecting to a host with a broker
(see Configuring the Tera2 PCoIP Zero Client to Automatically Log into a Host Brokered by a
Connection Manager).
Installing the Touch Screen Display
The following procedure shows you how to Install an Elo TouchSystems touch screen display.
To install an Elo TouchSystems touch screen display:
1. Plug in the touch screen's USB cable to the Tera2 PCoIP Zero Client's USB port.
2. Attach the monitor cable from the touch screen to any port on the Tera2 PCoIP Zero Client.

Don't attach multiple touch screens to the PCoIP Zero Client
You can't attach multiple touch screens to the Tera2 PCoIP Zero Client, but you can attach additional non-touch
screens to the Tera2 PCoIP Zero Client in addition to the touch screen as long as the touch screen is attached to
the port on the Tera2 PCoIP Zero Client that is configured as the
3. Plug in the power.
4. Disconnect the Tera2 PCoIP Zero Client session. This initiates the calibration on the touch
screen.
© 2020 Teradici
Setting Up a Touch Screen Display
OSD).
Device)
primary
Installing the Touch Screen
port.
Display).
229