Table of Contents
Advertisement
You can also configure an IP address from the AWI Initial Setup page
You can also assign an IP address (and other network settings) from the AWI Initial Setup page. To configure the IP
address from this page, see
To statically assign an IP address from the OSD:
1. From the OSD, select Options > Configuration > Network.
2. From the OSD Network page, select Unlock. If required, enter a password to make changes.
3. Ensure that Enable DHCP is not selected, and then enter the client's IP address and other
network addresses.
4. Click **Apply, and then click Reset to reset the device so the changes can take effect.
Locating the factory default IP address
You can locate the factory default IP address for a client in the IN OFD: (optional factory defaults) section of the the
device's event log:
The static fallback IP address can also be set from the PCoIP Management Console. In this case,
the event log will display the address as being IN FLASH: rather than IN OFD:
If you reset the client (see
will revert to the factory default, even when it has been set by the PCoIP Management Console.
© 2020 Teradici
Assigning the IP Address Statically
Configuring Initial Setup
Parameters.
Resetting Your Tera2 PCoIP Zero
Client), the static fallback IP address
217
Advertisement
Table of Contents
