Wacom Cintiq Pro 32 Manual page 125

Parameter
Logon
Password
Logon Domain
Name
Desktop Name
to Select
Certificate
Check Mode
Certificate
Check Mode
Lockout
Auto Connect
© 2020 Teradici
AWI: PCoIP Connection Manager + Auto-Logon Session Settings
Description
Enter the password for the client (maximum number of characters is 128). This password will be
sent to the specified connection server.
Enter the domain for the client (maximum number of characters is 256). This domain will be
sent to the specified connection server.
Enter the desktop name used by the client when starting a session.
This field is case sensitive.
Select the level of verification performed on the certificate presented by the connection server:
• Never connect to untrusted servers: Configure the client to reject the connection if a trusted,
valid certificate is not installed. (This is the most secure option.)
• Warn before connecting to untrusted servers: Configure the client to display a warning if an
unsigned or expired certificate is encountered, or if the certificate is not self-signed and the
Tera2 PCoIP Zero Client trust store is empty. (This option is selected by default.)
• Do not verify server identity certificates: Configure the client to enable all connections. (This
option is not secure.)
When enabled, prevents users from changing the Certificate Check Mode settings from the OSD
or AWI.
This field determines the client's auto connect behavior after startup:
Enabled: The client automatically connects with the connection server after startup and a PCoIP
session ends, bypassing the OSD Connect page.
Disabled: The client does not automatically connect with the connection server.
Enabled With Retry On Error: The client will continuously attempt to contact the connection server.
After a connection failure, the client waits before attempting to connect again. This wait time
increases with each successive failure. The wait interval is not configurable.
Devices running firmware 4.1.1 or lower do not support Retry On Error behavior and will always
perform a single attempt to contact the connection server when this option is selected.
After enabling Auto Connect, the client must be power-cycled for the change to take effect.
125