Wacom Cintiq Pro 32 Manual page 132

Parameter
DNS Name or
IP Address
Pool Name to
Select
Port
Certificate
Check Mode
Certificate
Check Mode
Lockout
Trusted View
Connection
Servers
Auto Connect
© 2020 Teradici
AWI: View Connection Server Session Settings
Description
Enter the View Connection Server's DNS name or IP address. For VMware Horizon DaaS, this is
the DNS name or IP address of the VMware Horizon DaaS Desktop Portal.
Enter the pool name. When the list includes a pool with this name, the client will immediately
start a session with that pool. This field is case-insensitive.
By default, port 443 is used to communicate with the connection server. If your network is set up
to use a non-standard port for secure connections, enter the port number.
Select the level of verification performed on the certificate presented by the connection server:
Never connect to untrusted servers: Configure the client to reject the connection if a trusted,
valid certificate is not installed. (This is the most secure option.)
Warn before connecting to untrusted servers: Configure the client to display a warning if an
unsigned or expired certificate is encountered, or if the certificate is not self-signed and the
Tera2 PCoIP Zero Client trust store is empty. (This option is selected by default.)
Do not verify server identity certificates: Configure the client to enable all connections. (This
option is not secure.)
When enabled, prevents users from changing the Certificate Check Mode settings from the OSD.
Click the Show button to display View Connection Servers for which the client has received a valid
certificate.
Click the Clear button to clear this cache.
This field determines the client's auto connect behavior after startup:
Enabled: The client automatically connects with the connection server after startup and a PCoIP
session ends, bypassing the OSD Connect page.
Disabled: The client does not automatically connect with the connection server.
Enabled With Retry On Error: The client will continuously attempt to contact the connection
server. After a connection failure, the client waits before attempting to connect again. This wait
time increases with each successive failure. The wait interval is not configurable.
Devices running firmware 4.1.1 or lower do not support Retry On Error behavior and will always
perform a single attempt to contact the connection server when this option is selected.
After enabling Auto Connect, the client must be power-cycled for the change to take effect.
132