Wacom Cintiq Pro 32 Manual page 101

Parameter
AWS
Connection
Name
Desktop Name
to Select
Certificate
Check Mode
Certificate
Check Mode
Lockout
Auto Connect
© 2020 Teradici
Description
Enter a name for this registered Amazon WorkSpace instance.
Enter the desktop name used by the client when starting a session.
This field is case-insensitive.
Select the level of verification performed on the certificate presented by the connection server:
• Never connect to untrusted servers: Configure the client to reject the connection if a trusted,
valid certificate is not installed. (This is the most secure option.)
• Warn before connecting to untrusted servers: Configure the client to display a warning if an
unsigned or expired certificate is encountered, or if the certificate is not self-signed and the
Tera2 PCoIP Zero Client trust store is empty. (This option is selected by default.)
• Do not verify server identity certificates: Configure the client to enable all connections. (This
option is not secure.)
When enabled, prevents users from changing the Certificate Check Mode settings from the OSD.
This field determines the client's auto connect behavior after startup:
• Enabled: The client automatically connects with the connection server after startup and a
PCoIP session ends, bypassing the OSD Connect page.
• Disabled: The client does not automatically connect with the connection server.
• Enabled With Retry On Error: The client will continuously attempt to contact the connection
server. After a connection failure, the client waits before attempting to connect again. This
wait time increases with each successive failure. The wait interval is not configurable.
Devices running firmware 4.1.1 or lower do not support Retry On Error behavior and will always
perform a single attempt to contact the connection server when this option is selected.
After enabling Auto Connect, the client must be power-cycled for the change to take effect.
AWI: Amazon WorkSpaces
101