Table of Contents
Advertisement
Overlay Window
Reboot overlay
Video Source Overlays
Improper connection of the host video source is denoted by two possible overlays, as shown next.
These overlays appear for approximately five minutes. The monitor is put into sleep mode
approximately 15 seconds after they appear.
Overlay Window
No source signal overlay
© 2020 Teradici
About Overlay Windows
Description
If a configuration change via AWI or Management Console
profile application requires a PCoIP Zero Client reboot, the
user will be provided with a warning of the pending reboot.
This will allow the user to save any work they may have
open. This setting is disabled by default. This setting can be
enabled and configured with any of 4 timing options. See
PCoIP Management Console
profile management information. This setting can be found
in the Management Console profile under the POWER
section or on the AWI Configuration > Reset page.
Available options:
• 0 seconds (disabled)
• 30 seconds
• 60 seconds (1 minute)
• 300 seconds(5 minutes)
Description
When no video source is connected to the host, this overlay
appears with the message: No source signal. This helps you
debug a situation where the host does not have the video source
connected or the host PC has stopped driving a video signal. To
correct this, connect the host PC video to the host. (This
message can also be triggered by the host going into display
power save mode.)
profile documentation
for
15
Advertisement
Table of Contents
