Table of Contents
Advertisement
Configuring USB Settings and Permissions
| Setting | Default | AWI | OSD | Management Console | | :---: | :---: | :---: | :---: | :--: | | Force Local
Cursor Visible | Disabled | | | | | Enable EHCI (USB 2.0) | Enabled | | | | | Authorized
Devices (Add new)| | | | | | Unauthorized Devices (Add new) | | | | | | Bridged
Devices (Add new) | | | | | | Devices Forced to USB 1.1 (Add new) | | | | |
From the AWI, you can configure USB settings and permissions.
Configure USB settings to enable the Tera2 PCoIP Zero Client to always show the local cursor, and
to configure EHCI (USB 2.0).
Configure USB permissions to authorize and unauthorize certain USB devices, configure devices
that need to be bridged to the host, and enable USB 2.0 Enhanced Host Controller Interface (EHCI)
mode.
Configuring USB audio devices
For information about configuring USB audio devices, see
Configuring USB Settings
From the AWI USB settings page, as shown next, you can configure parameters for devices
plugged into Tera2 PCoIP Zero Client USB ports.
The following parameters display on the AWI USB parameters page:
USB Parameters
© 2020 Teradici
Configuring USB Settings and Permissions
Configuring
Audio.
303
Advertisement
Table of Contents
