Wacom Cintiq Pro 32 Manual page 448

PCoIP Zero Client Quick Start Guide
ESTABLISHING A PCoIP CONNECTION
Your PCoIP Zero Client is pre-configured to connect directly to a PCoIP Remote Workstation Card,
but can be configured to use a third party connection broker such as VMware Horizon to connect
to virtual desktops or PCoIP Remote Workstation Cards. You can also connect to Teradici Cloud
Access Agents.
DIRECT CONNECT TO THE REMOTE WORKSTATION CARD
1. Power on host PC with PCoIP Remote Workstation Card.
2. Power on the Zero Client and the connected displays.
3. Ensure the Zero Client is on the same network as the Remote Workstation Card.
4. Wait until the Connect dialog appears on screen.
5. Select Connect and you will see the message Discovering hosts, please wait....
6. A list of available hosts is displayed.
7. Select the Remote Workstation Card you wish to connect to and click OK.
8. The display will show the host PC screen and the Zero Client's Session LED on the front panel
will turn green indicating a successful PCoIP connection.
DIRECT CONNECT TO A TERADICI CLOUD ACCESS AGENT
1. Power on a host PC with Cloud Access Agent installed.
2. Power on the Zero Client and the connected displays.
3. Wait until the Connect dialog appears on screen.
4. Browse to the OSD Session Page (Options > Configuration > Session)
5. Change the Session Connection Type to Auto Connect and enter the IP address of the host PC.
6. Select OK and then Connect.
INSTRUCTIONS FOR 2560X1600 / 3840x2160 RESOLUTION MONITORS
(Only DisplayPort models support 3840x2160 (4K UHD) resolution)
© 2020 Teradici
PCoIP Zero Client Quick Start Guide
(Standard Agent or Graphics Agent).
448