Wacom Cintiq Pro 32 Manual page 232

Parameter
Enable right
click on hold
Right click delay
Touch screen
calibration
To configure a touch screen from the OSD:
1. From the OSD, select Options > User Settings > Touch Screen.
2. From the OSD Touch Screen page, update the touch screen settings.
3. Click OK.
Setting up the Touch Screen as a Bridged Device

Setting up a touch screen as a bridged device is optional
This procedure is optional and only necessary if you want the touch screen to be set up as a bridged device.
While a session is active a user may want the touch screen to be controlled by a driver running on
the host. To set this up the touch screen must be added to the list of bridge devices.
To set up the touch screen as a bridged device:
1. Install the touch screen to your Tera2 PCoIP Zero Client (see Installing the Touch Screen
Display).
© 2020 Teradici
Setting up the Touch Screen as a Bridged Device
Description
Select this check box to let users generate a right-click when they touch the screen and hold it
for a few seconds. If disabled, right-clicking is not supported.
Slide the pointer to the position (between Long and Short) to determine how long the users
must touch and hold the screen to generate a right-click.
When you first connect the touch screen to the Tera2 PCoIP Zero Client, the calibration
program starts. At the touch screen, touch each of the three targets as they appear.
To test the calibration, run your finger along the monitor and ensure that the cursor follows it. If
it is not successful, the calibration program automatically restarts. Once calibrated, the
coordinates are stored in flash.
To manually start the calibration program, from the OSD Touch Screen page, click Start. Follow
the onscreen prompts.
232