Table of Contents
Advertisement
Configuring Multiple Displays
Setting
Enable Configuration
Layout
Alignment
Primary
Position
Rotation
Resolution
Depending on the Tera2 PCoIP Zero Client you have, you can attach up to two or four displays to
your device. Using the OSD Display Topology page, you can configure the position, rotation, and
resolution of the attached displays.
Before you configure multiple displays, make sure your setup has these components
• To apply the display topology feature to a PCoIP session between a client and a VMware Horizon virtual desktop,
you must have VMware View 4.5 or higher.
• To apply the display topology feature to a PCoIP session between a client and a PCoIP Remote Workstation Card,
you must have the Remote Workstation Card Software installed on the host.
Use the OSD, not the Windows Display Settings, to configure display settings
Always change the display topology settings using the OSD Display Topology page. Don't change these settings from
the Windows Display configuration page in a virtual machine when using VMware View.
© 2020 Teradici
Configuring Multiple Displays
Default
AWI
OSD
Disabled
Management Console
331
Advertisement
Table of Contents
