Table of Contents
Advertisement
Configuring 802.1x Network Device Authentication
Setting
Enable 802.1x security
Identity
Authentication
Client Certificate
Enable 802.1X Support for Legacy
Switches
This section describes the components you need to configure 802.1x authentication, and the
detailed steps you need to follow to configure the authentication.
Preparing for 802.1x Configuration
The supported 802.1x configuration has the zero client pre-populated with a proper certificate. It
then connects and presents the certificate to the 802.1x switch and is authenticated. PCoIP Zero
Clients will also connect under a different configuration of the switch which has the MAC address
of authorized endpoints stored in it's configuration.
Before you begin the configuration process, make sure you have these components:
• Tera2 PCoIP Zero Client with firmware 4.0.3 or later
• PCoIP Management Console 1.8.1 or later
• Windows Server 2008 R2 with AD DS (Active Directory Domain Services)
• Windows Server 2008 R2 with AD CS (Active Directory Certificate Services)
• Windows Server 2008 R2 with NPS (Network Policy and Access Services)
© 2020 Teradici
Configuring 802.1x Network Device Authentication
Default
TLS (this is the only available
setting)
AWI
OSD
Management
Console
345
Advertisement
Table of Contents
