Wacom Cintiq Pro 32 Manual page 307

Parameter
Bridged Devices
Devices Forced
to USB 1.1
The following figures show the parameters that display when you add a new USB authorized or
unauthorized entry. The parameters that display depend on whether you describe the device by
Class or ID.
Device class parameters
© 2020 Teradici
Configuring USB Permissions from the AWI
Description
Tera2 PCoIP Zero Clients locally terminate HID devices when connecting to VMware Horizon
virtual desktops. However, some devices advertise as HID but use different drivers. These
devices may need to be bridged to the host rather than locally terminated. This setting lets you
force the Tera2 PCoIP Zero Client to bridge specific USB devices so that they use the drivers on
the virtual desktop.
Add New: Add a device or device group to the list. This lets you bridge USB devices by their
Vendor ID and Product ID.
Bridging requires host support; USB bridging is not supported by all PCoIP hosts. See your
host's guide for more information.
Remove: Delete a rule for a device or device group from the list.
If a bridged USB device that is capable of EHCI (USB 2.0) does not perform normally over PCoIP,
you can use this table to force the device to use OHCI (USB 1.1) instead of EHCI (USB 2.0),
which may provide a better experience.
Add New: Add a device or device group to the list. This lets you bridge USB devices by their
Vendor ID and Product ID.
Remove: Delete a rule for a device or device group from the list.
Bridging requires host support; USB bridging is not supported by all PCoIP hosts. See your
host's guide for more information.
307