Ifc Test Mode - Siemens SWT 3000 Equipment Manual

4.2

IFC Test Mode

In order to switchover from normal to test mode with the service program PowerSys, select the IFC-Test in the
Testmode list box. In this mode, you can enter commands on the IFC module for each input with the DIP
switches S1.1 to S1.4
[scseltst-181011-01.tif, 1, en_US]
Figure 4-9
NOTE
i
i
For security reasons, after switching over to test mode, the controller signals all inputs as off regardless of
the actual switch position. The state on can only be reached by switching from off to on position. All
switches must be in the off position beforehand.
Also a General Alarm is given as long as the test mode is active. Furthermore the OK-LED is slowly blinking
during active test mode.
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
Selection of Testmode > IFC-Test
Diagnostics and Error Handling
4.2 IFC Test Mode
187