Data Source > New - Siemens SWT 3000 Equipment Manual

5.2.4.5 Data Source > New
After selection of the element New in the Data Source menu, select the device type that its parameter must
be set. Refer also to
unit, select the element SWT 3000. If SWT 3000 is integrated in PowerLink (iSWT), select the element Power-
Link. Select then the software release.
[scselpac-201113-01.tif, 1, en_US]
Figure 5-22
After that, define the name and place of storage of the database in which the data is stored.
[scdataba-201113-01.tif, 1, en_US]
Figure 5-23
NOTE
i
i
If you change an existing PowerLink or SWT 3000 configuration, use the Clear CDB command before
programming the new configuration into the CSPi or PU4. For more detailed information, refer to
Dialog Commands.
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
5.2.4.1 Overview for the selection of the device type. If SWT 3000 is used as a stand-alone
Release Selection
Defining a New Database
PowerSys and Auxiliary Software Tools
5.2 PowerSys Startup
4.3.1 The
219