Powersys Startup; Overview - Siemens SWT 3000 Equipment Manual

5.2

PowerSys Startup

Overview

5.2.1
After starting the program, the following dialog appears:
[scseprps-190413-01.tif, 1, en_US]
Figure 5-3
(1) Alarm bar: If the alarm display is red, the alarm is activated (only if the connection to the device
exists)
(2) DP: DP switched to secondary bitrate
(3) FSK: iFWT alarm (available only in PowerLink if iFWT is used)
(4) REM: Fault in the remote station
(5) NU: Non urgent alarm
(6) S/N: Signal to noise alarm
(7) RX: Receiver alarm
(8) TX: Transmitter alarm
(9) G: General alarm
(10) CFG: Configuration fault
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
Service Program PowerSys
PowerSys and Auxiliary Software Tools
5.2 PowerSys Startup
205