Ntp Daylight Saving Time - Siemens SWT 3000 Equipment Manual

SNMP and Remote Access
6.4 Web Interface
Table 6-15
Settings
NTP Server IP-Address
NTP activated
Timezone Offset [hh:mm]
Poll Interval [1-65000 sec]
Send
Reset
The NTP Server IP-Address must be set according to the customers network.
6.4.4

NTP Daylight Saving Time

Network Time Protocol (NTP) is a networking protocol to synchronize the clock between an NTP server and a
SWT 3000 device. No information of time zone or daylight saving time (summer time) is provided by NTP,
which has to be configured manually using the Web server or SNMP SET command.
The Universal Time Coordinated (UTC) received from the NTP server will be adjusted with the setting of local
time zone or daylight saving time.
[scdaylig-300414-01, 1, en_US]
Figure 6-33
Settings
Summer Time Switchover This enables daylight saving time switchover, it is only relevant for NTP.
Summer Time Offset to
GMT [hh:mm]
302
NTP Settings
Comments
Actual Network Time Protocol (NTP) server.
The NTP server is the PC in the network providing the time. Enter either the
IP address or the Internet address.
Activation of the NTP (NTP activated check box on ) offers the possibility to
synchronize the time of the SWT 3000 via NTP protocol.
Default: NTP activated check box off ( )
The time zone is always the GMT. Select the local deviation (up to ±12 h).
The poll interval describes how often the time is read from the NTP server.
Send the values to the PU4 module.
Reject the changes.
SWT 3000 NTP Daylight Saving Time Setting using the Web Server
Comments
If it is enabled, you have to configure the summer time offset, the begin and the
end of summer time also.
Daylight saving time offset to GMT (Greenwich Mean Time).
The possible range of value: -12:00 to 12:00
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020