Siemens SWT 3000 Equipment Manual page 4

Preface
The device is designed and manufactured for application in industrial environment:
•
Emitted interference: EN 61000-6-4: 2001
•
Immunity to interference: EN 61000-6-2: 2001
For use in residential areas you also need the individual authorization of a national authority or test agency
with respect to emitted interference.
The test and connection jacks accessible at the front are not isolated interfaces and are only used for mainte-
nance purposes. The usual ESD measures must be observed in use. This also applies for the use of telephone
connection sockets (if present).
NOTE
i
i
All signal and data cables are shielded and connection of the shielding over a large area must be provided
at both ends.
The products and systems listed here are manufactured and marketed using a DQS-certified quality manage-
ment system in accordance with ISO 9001.
Additional Support
For questions about the system, contact your Siemens sales partner.
Support
Our Customer Support Center provides a 24-hour service.
Siemens AG
Customer Support Center
Humboldtstraße 59
90459 Nürnberg
Germany
Phone: +49 (180) 524-7000
Fax: +49 (180) 524-2471
E-mail: support.energy@siemens.com
Notes on Safety
This document is not a complete index of all safety measures required for operation of the equipment (module
or device). However, it comprises important information that must be followed for personal safety, as well as
to avoid material damage. Information is highlighted and illustrated as follows according to the degree of
danger:
!
DANGER
DANGER means that death or severe injury will result if the measures specified are not taken.
Comply with all instructions, in order to avoid death or severe injuries.
²
!
WARNING
WARNING means that death or severe injury may result if the measures specified are not taken.
Comply with all instructions, in order to avoid death or severe injuries.
²
4 Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020