The Data Source Menu; Overview; Device; Remote Device - Siemens SWT 3000 Equipment Manual

The Data Source Menu

5.2.4
5.2.4.1

Overview

[scnewcon-141011-01.tif, 1, en_US]
Figure 5-19
Select New in the Data Source menu for the selection of the device type (PowerLink or SWT 3000).
Table 5-3
Selection

Device

Remote Device

Disconnect
File
New
Close
5.2.4.2 Device
If you select Data Source > Device, the data are read in from the connected terminal. The program attempts
to establish a connection to the unit (PowerLink or SWT 3000) and then loads the data of the unit into the
system memory of the service PC. Afterwards, the downloaded data can be processed. The program detects
from which unit (PowerLink or SWT 3000) the data were read and automatically changes to the appropriate
program level.
5.2.4.3 Remote Device
Remote device denotes the Remote Monitoring function of the unit.
With this function, device data can be transmitted between one of the following cases:
•
The terminals of one or more carrier frequency (CF) routes
•
2 PowerLink or SWT 3000 units
•
RM connection can be established over a chain of equipment
NOTE
i
i
This function requires activating the RM and a corresponding configuration and address setting in the
devices.
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
The Data Source Menu
Functions of the Data Source Menu
Function
Establishing the connection to the device
Establishing the connection to a remote
device
Disconnecting the device
Load the parameter from a (.ddb) file
New configuration
Selecting the device type
Abort the connection to the device
PowerSys and Auxiliary Software Tools
5.2 PowerSys Startup
Comment
-
RM must be configured.
-
ddb files from the same release are
compatible and can be used for restoring a
configuration. After changing the release,
Siemens recommends that you create a
new device configuration with Data
Source > New.
-
-
217