Powersys Startup Parameter - Siemens SWT 3000 Equipment Manual

[scoffpow-060712-01.tif, 1, en_US]
Figure 5-25
5.2.4.7

PowerSys Startup Parameter

For an easier and dedicated access to a PowerLink or SWT 3000 device with remote connection, it should be
possible to start up PowerSys with predefined connection parameters (e.g. target IP address). Thus, PowerSys
can be used in Network Management System (NMS) for direct individual device connection by double-clicking
a PowerLink or SWT 3000 device icon. PowerSys application can be opened and connected to a device from
NMS automatically.
The connection information can be shown in the PowerSys status bar.
The new content includes:
•
IP address, COM port number or RM address
•
Device name
•
User level
•
SSL Encryption (if used)
Startup Parameter Configuration
The usage of PowerSys startup command line is as below.
Table 5-4
PowerSys_35110.exe [/P | /F] [IP address],[user level],[password],[RM address],[SSL Encryption]
Startup Command
/P
/F
IP address
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
Offline Tree Window for PowerLink
Startup commands
Description
Startup parameter is read from command line
Startup parameter is read from configuration file "StartupPara.txt", which is
located at:
<PowerSys Installation Path>\PowerSys\<version>\StartupPara.txt
IP address used to connect to the target. This is a mandatory parameter.
PowerSys and Auxiliary Software Tools
5.2 PowerSys Startup
221