Memtool Installation; General Information; Overview; System Requirements - Siemens SWT 3000 Equipment Manual

5.4

MemTool Installation

General Information

5.4.1
5.4.1.1

Overview

This description is the upgrade instruction for the controller card of SWT 3000. For firmware download of
SWT 3000, a dedicated FLASH-PROM programming tool can be used. The MemTool flash programming soft-
ware is provided with the PowerSys DVD and ensures easy and quick product upgrade if required.
Program files are delivered as AllInOne*.jnk. Typically the files are part of the PowerSys software package
available on DVD. After installing the service program PowerSys, the files are saved in the folder Hard disk
\Program Files\PowerSys\Px.y.z\Firmware.
5.4.1.2

System Requirements

To run MemTool, the following minimum system configuration is required:
Operating system
Processor
Clock
System memory
DVD drive
Ethernet interface
Serial (local) interface
Printer interface
5.4.1.3

Version of MemTool

MemTool release V3.0 or higher
5.4.2

Installation of MemTool

NOTE
i
i
It is necessary to install MemTool under administrator rights. Furthermore, it is required to remove previous
MemTool versions before installation.
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
Windows 7, Windows 8, Windows 8.1, Windows XP, Windows VISTA or
Windows 10
Pentium or better (or processor with equivalent performance)
Minimum 1 GHz
1 GB
10/100Base-T
USB
LPTx (optional)
PowerSys and Auxiliary Software Tools
5.4 MemTool Installation
227