Siemens SWT 3000 Equipment Manual page 244

PowerSys and Auxiliary Software Tools
5.5 PU4 Firmware Upgrade with Mem Tool
[scsucpro-250711-01.tif, 1, en_US]
Figure 5-48
After successful upgrade, click Exit.
For external FLASH module, the sector table is created after determining the actual type of the FLASH.
Select ext FLASH in the Flash/OTP - Memory Device list box.
If the connection fails, reset the PU4 module and try again. For more detailed information, refer to
5.5.5 Trouble Shooting.
Click Erase ... to erase the external FLASH.
[scdicose-150911-01.tif, 1, en_US]
Figure 5-49
Click Program to start the programming cycle. The Execute MemTool Command dialog appears and shows
the programming progress. The upgrade starts with programming and verification.
After successful upgrade, click Exit.
Click Disconnect and then Exit to close the MemTool main dialog.
244
Dialog After a Successful Programming
Dialog of the Connection to SWT 3000 for External FLASH
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020