Siemens SWT 3000 Equipment Manual page 162

Installation and Commissioning
3.5 Device Configuration
[ScDefault-23022015, 1, en_US]
Figure 3-53
System Alarms for Allocation
It is possible to change the default setting and to allocate alarms listed in
ALR module. Multiple alarms can be allocated to the same relay output.
Table 3-55
System Alarm
RXALR
NUALR
GENALR
TXALR
IFC-1 ALR
IFC-2 ALR
IFC-3 ALR
IFC-4 ALR
EN100-IEC 61850 ALR
FOM-1 ALR
FOM-2 ALR
LIA ALR
LID-1 ALR
LID-2 ALR
EN100-TPoP ALR
Power Failure ALR
162
Default Settings for the Alarm Output Allocation
System Alarm Description
Description
Receive alarm
Non-urgent alarm
General alarm
Transmission alarm
IFC-1 module alarm (hardware alarm)
IFC-2 module alarm (hardware alarm)
IFC-3 module alarm (hardware alarm)
IFC-4 module alarm (hardware alarm)
EN100 module with IEC 61850 protocol alarm
FOM-1 module alarm
FOM-2 module alarm
Analog line interface alarm
Digital line interface 1 alarm
Digital line interface 2 alarm
EN100 module with teleprotection Over Packet protocol alarm
Power failure alarm
Table 3-55
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020
to any relay output of an