Powersys Installation; About The Service Program Powersys; Pc Requirements; Installation Of The Service Program Powersys - Siemens SWT 3000 Equipment Manual

PowerSys and Auxiliary Software Tools

5.1 PowerSys Installation

5.1 PowerSys Installation

About the Service Program PowerSys

5.1.1
The Service program PowerSys is required for commissioning, maintenance, and diagnosis of the PowerLink or
SWT 3000 units. The following description applies to the program versions P3.5.x and higher. The term SWT
3000 is employed for stand-alone protection signaling units and iSWT for devices integrated in PowerLink.
5.1.2

PC Requirements

Operating system
Processor
Clock
System memory
DVD drive
Ethernet interface
Serial (local) interface
Additional needed software
5.1.3

Installation of the Service Program PowerSys

With the service program PowerSys versions P3.5.x and higher, multiple installation is possible. Older versions
can be removed.
You can uninstall older PowerSys versions via Start > Settings > Control Panel > Add or Remove Programs
by clicking Remove.
NOTE
i
i
Data files stored in older versions, for example, in C:\Program Files\PowerSys\P3.x.y\DeviceFiles are not
uninstalled and may be used again after reinstalling the older version.
The new service program PowerSys is delivered on a DVD. Run the setup.exe for the installation. The
program leads you through the installation.
202
Windows 7, Windows 8, Windows 8.1, Windows XP, Windows VISTA or
Windows 10
Pentium or better (or processor with equivalent performance)
Minimum 1 GHz
1 GB
10/100Base-T
USB
Microsoft .NET Framework
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020