Safety Instructions
1.7 Replacement
Connect the leads to the terminals.
²
Then check for secure attachment of the connectors.
²
Mount and fasten the front plate on the device.
²
Completing Replacement
1.7.2
Set the jumpers of the module for operation mode.
²
The device shall recognize the new plug-in module.
²
In case you installed a new module, configure the settings of the new module in PowerSys.
²
NOTE
i
i
Only qualified electrical engineering personnel is authorized to reset the hardware parameters.
30
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020