Data Source > File - Siemens SWT 3000 Equipment Manual

PowerSys and Auxiliary Software Tools
5.2 PowerSys Startup
The following dialog appears after selection of Remote Device in the Data source menu:
[scremcon-201113-01.tif, 1, en_US]
Figure 5-20
The target Remote device address is entered here. For example, the target device of the unit with which an
RM link must be established. The RM address of the connected unit is set with the Configuration menu.
Set and confirmed the address by clicking Ok or aborted by clicking Esc or Cancel. After the connection is
established, all data of the remote device are downloaded. The duration of this procedure depends on the
transmission data rate (50 bps or 300 bps). Afterwards, the PowerSys menu tree for the remote device is
displayed.
5.2.4.4 Data Source > File
With selecting Data Source > File, the following dialog opens for selecting the file that must be loaded.
[scloddat-201113-01.tif, 1, en_US]
Figure 5-21
After the file has been loaded, the data can be modified or programmed in the device.
218
Dialog for Establishing a Remote Connection
Loading the Data from an Existing File
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020