Application; Output Allocation - Siemens SWT 3000 Equipment Manual

Installation and Commissioning
3.5 Device Configuration
3.5.4.5

Application

Coded Transmission
Switchover from the F6 modulation to the coded transmission.
Refer to Functional Description).
For the operating modes 3, 5A, or 6, the coded transmission is not adjustable.
Direct Tripping
This setting offers enhanced transmission security of the analog interface and must be selected for teleprotec-
tion systems with direct tripping. The transmission time is about 3 ms longer compared with the setting
permissive tripping.
Permissive Tripping
This setting must be selected for permissive protection systems.
3.5.5

Output Allocation

[scoutall-121011-01.tif, 1, en_US]
Figure 3-24
In the SWT 3000 system, every possible combination of binary inputs is permanently assigned to a protection
frequency depending on the operating mode (Mode 1 to Mode 5A) and the function unblocking On or Off.
At the receiving end, every protection frequency can be assigned to one or more signal outputs (CO1 to CO4)
with the output allocation for the operating mode Mode 3a and 5A.
In digital operation, it is also possible to assign the outputs to the activated binary inputs for the operating
mode Mode 5D.
You can load a preset allocation by clicking on Default. All allocation settings are deleted by clicking on Clear.
You can store the settings as files by clicking on Save and call them up again with Load.
This assignment is permanently set for the operating modes Mode 1, 2, 3, and Mode 4 and cannot be
changed with the output allocation.
134
Configuration Menu Output Allocation, e.g. for Operating Mode 5A
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020