Ethernet Interface Settings - Siemens SWT 3000 Equipment Manual

SNMP and Remote Access
6.4 Web Interface

Ethernet Interface Settings

6.4.2
The Ethernet interface is used for:
•
The communication between the NMS and SWT 3000
•
Remote PowerSys session
[scethset-300414-01, 1, en_US]
Figure 6-31
(1) You can not change the fields with the dark blue color.
(2) You can change the fields with the light blue color.
(3) Fields have to be activated in PowerSys program
Table 6-14
Settings
MAC address
IP-Address
Subnet-Mask
Gateway
Predefined IP-Address
Predefined Subnet-Mask
Predefined Gateway
IP-Address Resolution Mode
•
DHCP
•
Predefined
Service Port
300
Ethernet Interface Settings
Ethernet Interface Settings
Comments
Actual MAC address of the PU4 Ethernet interface
Actual IP address of the PU4 Ethernet interface
Actual Subnet Mask
Actual gateway
User defined IP address
User defined subnet mask
User defined gateway
•
Ethernet interface is connected to a DHCP server and expects an IP
address.
•
IP address and subnet mask and gateway address for the Ethernet
interface defined by the user.
The values given in the fields Predefined are written to the PU4
module after clicking the SEND button in the Activation of Settings
page. After restart of SWT 3000, this user given values are valid as
actual IP address and subnet mask.
RAS port number
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020