Siemens SWT 3000 Equipment Manual page 370

Technical Data
14.2 Command Input/Output
Binary Command Output IFC-S for Signaling
Contact type
Contacts per module
Contact material
Switching power
Switching voltage
Switching current per contact
Carry current
Switching current per IFC-S module
Insulation withstand voltage
Contact configuration
Connection cable
Electric strength of contacts/coil
Binary Input IFC-MCM Basis and Sub Module for PowerLink 100
Rated input voltage *)
Threshold
Polarity independence
Pulse suppression
Hardware debounce time
*) Regardless of the adjusted input voltage the max. voltage of DC 287.5 V can be connected
Command Output IFC-MCM (Relay) for PowerLink 100
Contact type
Switching power
Switching voltage
Switching current
Carry current
Command Output IFC-MCM (Solid State Relay) for PowerLink 100
Contact type
Switching power
Switching voltage
Switching current
Carry current
IEC 61850 Command Input/Output EN100
Electrical interface
Optical interface
Transmission rate
370
Relay CO, changeover with common root
8
Silver Tin Oxide
150 W/1250 VA
AC/DC 250 V
AC/DC 5 A (30 A ≤ 0.5 ms)
AC/DC 1 A
8 A
AC 3 kV
Single pole, configurable: normally open or normally closed
Common reference voltage
≤ 2.5 mm 2 (modular terminal block)
AC 3000 V
DC 24 V to DC 250 V (tolerance: -20 % to +20 %)
70 % of rated DC input voltage (24 V, 48/60 V, 110 V,
220 V)
Yes
1 ms
additionally up to 100 ms programmable in steps of 1
ms
0.6 ms or 1 ms
adjustable with jumpers
Relay, make contact
150 W (DC)
1250 VA (AC)
220 V (DC)
5 A (DC or peak AC)
5 A (DC or peak AC)
Semi-conductor electrically isolated, make contact
50 VA
250 V (DC or peak AC)
2 A (DC or peak AC)
2 A (DC or peak AC)
RJ45, 100BaseT, max. range 20 m
1300 nm, LC connector, max. range 1.5 km, Multimode
100 Mbps (Fast Ethernet)
Smart Communication, SWT 3000 Teleprotection, Equipment Manual
C53000-G6040-C605-1, Edition 03.2020