Irf Auto-Merge Enable - HP FlexFabric 7900 Series Command Reference Manual

MAD LACP enabled.
MAD BFD disabled.
# Display detailed MAD information.
<Sysname> display mad verbose
Current MAD status: Detect
Excluded ports(configurable):
FortyGigE2/1/0/2
FortyGigE2/1/0/3
Excluded ports(can not be configured):
FortyGigE1/9/0/1
FortyGigE1/9/0/2
FortyGigE1/9/0/3
FortyGigE1/9/0/4
FortyGigE2/9/0/1
FortyGigE2/9/0/2
FortyGigE2/9/0/3
FortyGigE2/9/0/4
MAD enabled aggregation port:
Bridge-Aggregation2
MAD BFD enabled interface:
Vlan-interface2
mad ip address 10.0.0.2 255.255.0.0 member 1
mad ip address 10.0.0.3 255.255.0.0 member 2
Table 6 Command output
Field
Current MAD status
Excluded ports(configurable)
Excluded ports(can not be
configured)

irf auto-merge enable

Use irf auto-merge enable to enable IRF auto merge. The function enables an IRF fabric to automatically
reboot its member devices if it fails in the master election during an IRF fabric merge.
Use undo irf auto-merge enable to disable this function.
Description
MAD status:
•
Detect—The IRF fabric is integrated.
•
Recovery—IRF fabric is in Recovery state. When detecting a
multi-active collision, MAD places the IRF fabric with higher master ID
in Recovery state. MAD also shuts down all physical ports in the fabric
except IRF physical ports and ports that are configured to not shut
down.
•
Detect to Recovery—State of the IRF fabric is changing from Detect to
Recovery, for example, as the result of an IRF split.
•
Recovery to Detect—State of the IRF fabric is changing from Recovery
to Detect.
Ports manually configured to not shut down when the IRF fabric transits to
the Recovery state.
Ports set by default to not shut down when the IRF fabric transits to the
Recovery state.
9