Receptacle Fuse Link - Club Car IQ Plus 2008 Maintenance And Service Manual Supplement

13
ELECTRICAL COMPONENTS
TYPICAL
4 PLACES

RECEPTACLE FUSE LINK

The fuse link on the 48-volt Club Car electric vehicle should not blow under normal operating conditions; how-
ever, if the fuse link has blown, the vehicle will not charge and the fuse must be replaced. The fuse link (6) is
mounted on top of the charger receptacle in the battery compartment (Figure 13-11, Page 13-14).
Receptacle Fuse Link Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove the fuse link (6) from the charger receptacle (5) by removing the two nuts and washers used to
secure the 10-gauge black wire (11) from the computer and the 10-gauge black wire to the receptacle
(Figure 13-11, Page 13-14).
3. Remove the fuse link (6) from the charger receptacle.
Receptacle Fuse Link Installation
1. Insert the two fuse link mounting posts into the mounting holes in the charger receptacle.
2. Place the two 10-gauge black wires in their original positions on the fuse link mounting posts.
3. Install nuts (7) on fuse link mounting posts and tighten to 23 in-lb (2.6 N·m) (Figure 13-11, Page 13-14).
Page 13-14 2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
1
11
Figure 13-11 Charger Receptacle
6
7
TYPICAL
2 PLACES
10 9 4 8
Charger Receptacle
TYPICAL
3 PLACES