Solenoid - Club Car IQ Plus 2008 Maintenance And Service Manual Supplement

13
ELECTRICAL COMPONENTS
Installing the Speed Controller Cover
1. Place the curved edges on the bottom of the speed controller cover (2) into the slots on the component
mounting plate.
2. Press the speed controller cover onto the component mounting plate over the speed controller and other
electrical components.
3. Install the three push rivets (1) (Figure 13-6).

SOLENOID

See General Warning, Section 10, Page 10-1.
The solenoid is located on the passenger side of the electrical component mounting plate.
Testing the Solenoid
See Section 11, Test Procedure 3, Page 11-17 and Test Procedure 15, Page 11-41.
Solenoid Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Remove the speed controller cover. See Removing the Speed Controller Cover on page 13-7.
3. Disconnect all wires from the solenoid (Figure 13-7, Page 13-9).
4. Loosen, but do not remove, the two screws (1) that hold the solenoid (2) to the component mounting
plate.
Page 13-8 2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
Figure 13-6 Speed Controller Cover
1
2
Solenoid