Motor Controller Output Regulator (Mcor) - Club Car IQ Plus 2008 Maintenance And Service Manual Supplement

13
ELECTRICAL COMPONENTS

MOTOR CONTROLLER OUTPUT REGULATOR (MCOR)

See General Warning, Section 10, Page 10-1.
Testing the MCOR
See Section 11, Test Procedure 4, Page 11-18 and Test Procedure 9, Page 11-23.
MCOR Removal
1. Disconnect the batteries and discharge the controller. See Disconnecting The Batteries on page 10-3.
2. Place chocks at rear wheels and lift the front of the vehicle with a chain hoist or floor jack. Place jack
stands under the round tube crossmember of the frame to support vehicle. See WARNING "Lift only
one end..." in General Warning, Section 10, Page 10-2.
3. Disconnect the two-pin and three-pin connectors (1) from the MCOR (2) (Figure 13-5, Page 13-6).
4. Remove the hex-head screws (3) connecting the MCOR to the frame I-beam.
5. Remove the MCOR from vehicle.
6. Push the drive bar (4) into the hole in the I-beam to disengage it from the accelerator pivot rod (5).
Page 13-6 2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
5
Figure 13-5 Motor Controller Output Regulator (MCOR) Mounting
Motor Controller Output Regulator (MCOR)
4
3
2
1