Body And Chassis; Pedal Operation; Brake Pedal; Accelerator Pedal - Club Car URBAN N1 User Manual

Table of Contents

Body and chassis

Always visually inspect the chassis and body to make sure that all chassis and body

parts are present, correctly mounted and undamaged before using.

Check that all electrical functions are working correctly. This includes:

• Headlamps, both high and low beam

• Position lights

• Turn signal indicators

• Horn

• Hazard lights

• Windshield wiper/washer

Perform the following check on the pedal operation to ensure that pedals are working

correctly as specified below.

Always make sure that brakes are functioning correctly. Do not drive, if brakes are not

functioning correctly.

When engaging the brake pedal, the pedal should show resistance after being de-

pressed approximately 1/3 of its way. If it is possible to push the brake to the floor

without any resistance, it is an indication of a malfunction in the braking system.

Please consult a qualified repair shop immediately. It is recommended that repairs are

provided by an Authorized Club Car Service Dealer. The pedal should feel firm at all

times and always return to its original position when released.

Before checking, ensure that (with the iginiton key turned to "OFF"). Make sure that

the accelerator pedal is working correctly and moving freely, and the pedal returns to

its original position when released.

Always ensure that the ignition switch is turned "OFF" before the pedal

operation is tested. Vehicle can accelerate abruptly if vehicle is set to the

"D" or "R" position and potentially cause severe injury to persons or dam-

age to property.

U21 982 005 00 Club Car Urban N1 user's manual, 1st edition

WARNING

SAFETY

Table of Contents