Receiver Mode - F110 Model; Transceiver Mode - F110 Model - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
4. UBEX Concept 4. UBEX Concept
4.2.5. Receiver Mode - F110 Model
Port Diagram
The port diagram is valid for the following UBEX endpoint model:
▪ UBEX-PRO20-HDMI-F110
Port diagram of the F110 receiver
Description
The device is built with a 4x3 digital audio crosspoint which has four inputs: three digital audio streams are
received from the SFP+ links. The fourth input is the stream of the analog audio in port. The audio streams
can be selected to the HDMI out 1 and 2, and the analog audio out ports.
The stream of the analog audio in port is transmitted toward the remote endpoint device over the SFP+ links.
The HDMI input ports do not accept signals when the device is configured as receiver.
Signal Support of the Analog Audio Output
The UBEX-PRO20-HDMI-F110 endpoint model converts the uncompressed stereo audio stream to analog audio.
The analog audio output port supports PCM audio format up to 48 kHz.

ATTENTION! If unsupported audio signal is selected to the analog audio output, the port will be muted
automatically. The current status of the port can be queried by an LW3 protocol command, see the details
in the Query the Status of the Analog Audio Output
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
section.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
4.2.6. Transceiver Mode - F110 Model
Port Diagram
The port diagram is valid for the following UBEX endpoint model:
▪ UBEX-PRO20-HDMI-F110
Port diagram of the F110 transceiver
Description
The device is built with a 4x2 digital audio crosspoint which has four inputs: two of them are received on
the SFP+ links; the stream of the analog audio in, and the stream of the HDMI in 2 port. Any audio can be
selected to the HDMI out 1 and the analog audio out ports.
The audio streams of the HDMI in 2 and the analog audio in ports are transmitted via the SFP+ output ports
toward the remote endpoint device.
The HDMI out 2 port is a local output port, it transmits the audio stream of the HDMI in 2 port directly.
The HDMI input 1 port does not accept signal when the device is configured as transceiver.
Signal Support of the Analog Audio Output
The UBEX-PRO20-HDMI-F110 endpoint model converts the uncompressed stereo audio stream to analog audio.
The analog audio output port supports PCM audio format up to 48 kHz.
ATTENTION!
If unsupported audio signal is selected to the analog audio output, the port will be muted
automatically. The current status of the port can be queried by an LW3 protocol command, see the details
in the Query the Status of the Analog Audio Output section.
42 42