Protocol Description; Instructions For The Terminal Application Usage - Lightware HDMI-TPS-TX210 User Manual

   
6.LW2Programmer'sReference
6.1. Protocol Description
TheprotocoldescriptionhereinafterstandsforLightwareprotocol.Thecommandscanbesenttothedevice
inRAWformatviatheTCP/IPportno.10001.
The receiver accepts commands surrounded by curly brackets - { } - and responds data surrounded by
roundbrackets-()-onlyifacommandwassuccessfullyexecuted.Allinputcommandsareconvertedto
uppercase, but respond commands can contain upper and lower case letters as well.
Legend for Control Commands
Format
<in> Inputnumberin1or2digitASCIIformat(01,5,07,16,etc.)
<out> Outputnumberin1or2digitASCIIformat
<in/out> inputoroutputportnumberin1or2digitASCIIformat*
<in2> Inputnumberin2digitASCIIformat(01,02,10,12etc.)
<out2> Outputnumberin2digitASCIIformat(01,02,10,12etc.)
<in2/out2> inputoroutputnumberin2digitASCIIformat*
<loc> Locationnumberin1,2or3digitASCIIformat
<id>
<id2>
CrLf
·
→ 

*Thecommandhasthesameargumentsontheinputportsandtheoutputport,aswell.
Explanation
idnumberin1or2digitASCIIformat
idnumberin2digitASCIIformat
Carriagereturn,Linefeed(0x0D,0x0A)
Spacecharacter(0x20)
Each command issued by the controller
Each response received from the router
Appliedfirmwarepackage:v1.2.0 | LDCsoftware:v2.2.0
HDMI-TPS-TX200series–User'sManual
6.2. Instructions for the Terminal Application Usage
Terminal Application
TheLW2 protocol commands can be appliedto the
receiver using a terminal application. You need to
install one of them to your control device, for example
Putty or CLI. #terminal #new
Establishing Connection
Follow the steps for establishing connection to the
receiver:
Step 1. ConnectthereceivertoaLANoverEthernet.
Step 2. Opentheterminalapplication(e.g.Putty).
Step 3. Add the IP address of the device (default:
192.168.0.100)andtheport number (10001).
Step 4. SelecttheRaw connection type, and open the
connection.
Once the terminal window is opened, you can enter
theLW2protocolcommandswhicharelistedinthe
followingsections.
LW2 protocol command communication in a terminal window
57