Table of Contents
Advertisement
4. Software Control - Lightware Device Contoller
4.3. Control menu
The Control menu shows basic information about the extender(s) in three panels. The Connected text is
displayed in the extender's title that is connected to the computer directly.
Parameter
Connected: Transmitter and Receiver are linked
Fiber link
Disconnected: no fiber connection
DP link speed and channels
According to the incoming signal (only in DP mode)
DisplayPort
Video mode
HDMI: passive adaptor is connected to the receiver
ON: source is present in DP mode
Video source state
Not connected: source is not connected
n/a: no information about the signal (HDMI mode)
ON: DP or HDMI display
Monitor state
OFF: display device is not connected
checked: HDCP enabled
HDCP enable
unchecked: HDCP disabled
4.3.1. Video and Link Panel
Basic information is displayed about the extenders and the video signal. If the extenders are linked by fiber
cable, they can read information about each other and display.
INFO:
Source can be forced to send unencrypted signal (if the content allows) by unchecking the HDCP
enable setting.
INFO:
HDCP enable setting can be changed in DP and HDMI mode also, but effects only when DVI/HDMI
adaptor is connected. When HDCP is changed in DP mode, the setting is stored and will be applied when
an adaptor is connected.
DP-OPT-TX150, DP-OPT-RX150 – User's Manual
State and Description
Applied firmware package: v1.1.13 | LDC software: v2.5.1b5
4.3.2. Transmitter Panel
The Control menu
Two channels are used for the USB communication, which can be set as described in the
section. Channel 1 is always transparent, Channel 2 can be set to transparent or configuration
mode.
Parameter
USB host (computer)
Connected
USB Channel 1 mode
Transparent (always)
Active
USB Channel 1 state
Not connected (it depends on the HID devices)
Configuration
USB Channel 2 mode
Transparent
USB Channel 2 status
Active
ATTENTION!
USB Channel 2 mode can be changed by a drop-down menu. When switched to
transparent mode, the extender is disconnected from the LDC immediately.
18
USB Modes
State and Description
Advertisement
Table of Contents
