Remote Control (Hsp5-Extension); Other Operators; Keyboard Operation; Parameter Numbers And Values - KEB COMBIVERT F5 Installation Manualline

Operation of the Unit
RS232-cable 3m
PC / Operator
Part number 00.58.025-001D

4.1.4 Remote control (HSP5-extension)

The HSP5-extension is connected between the COMBIVERT and the operator. It serves
for the remote control of the COMBIVERT. The HSP5-extension is equipped with special
cable drivers. Therefore the use of conventional RS232-cables is not permitted. The last
three digits of the part number indicate the length of the cable in dm (00.F5.0C0-1005, -
1010, -1030 and 1100).

4.1.5 Other operators

In addition to the described operators the KEB COMBIVERT can be equipped with further
operators for special applications (Profibus, Interbus, Sercos, CAN, DeviceNet). You find
further information on that on our home page.
4.2

Keyboard Operation

4.2.1 Parameter numbers and values

When switching on KEB COMBIVERT F5 the value of parameter CP.1 appears.
The function key (FUNC) changes
between the parameter value and
parameter number.
With UP and DOWN the value of the
parameter
decreased with changeable parameters.
Principally during a change, parameter values are immediately accepted and stored non-
volatile. However, with some parameters it is not useful that the adjusted value is accepted
immediately. In these cases the adjusted value is accepted and stored non-volatile by
pressing ENTER. When this type of parameter is changed a point appears behind the last
digit.
By pressing „ENTER" the adjusted value
is accepted and non-volatile stored.
9pole SUB-D female
Housing (PE)
number is increased/
2
3
5
PC
STOP
START
2
3
7
F5-Operator
FUNC.
SPEED
STOP
START
ENTER
F/R
19