Mx2008 Sfb Led And Buttons On The Craft Interface; Mx2008 Fan Tray Leds On The Craft Interface - Juniper MX2008 Hardware Manual

NOTE: When installing an adapter card without the line card, the online/offline buttons have
no effect.

MX2008 SFB LED and Buttons on the Craft Interface

Each SFB has one bicolor LED on the craft interface that indicates its status. The SFB LEDs, labeled 0
through 7, are located along the bottom of the craft interface.
of the SFB LED.
Table 15: SFB LED on the Craft Interface
Label Color
SFB Green
–
Red
There are eight push buttons located next to each of the SFB LEDs on the craft interface. These buttons
are used to place the SFBs online or offline.

MX2008 Fan Tray LEDs on the Craft Interface

The fan tray LEDs, labeled 0 and 1, are located on the top middle of the craft interface.
describes the functions of the fan tray LEDs.
Table 16: Fan LEDs on the Craft Interface
Label Color
FANTRAYS Green
Red
State Description
On SFB functioning normally.
steadily
Blinking SFB is transitioning online or offline.
Off The slot is not online.
On SFB has failed.
steadily
State Description
On Fan is functioning normally.
steadily
On Fan in a fan tray has failed.
steadily
Fan tray has failed.
Table 15 on page 49 describes the functions
Table 16 on page 49
49