Table of Contents
Advertisement
CAUTION:
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
6. Immediately cover each optical transceiver and the end of each fiber-optic cable with a rubber safety
cap.
7. Arrange the disconnected cables in the standard upper and lower cable managers to prevent the cables
from developing stress points.
8. Simultaneously turn both of the ejector handles outward to unseat the MPC along with the adapter
card.
9. Grasp the handles, and slide the combined cards straight out of the card cage halfway.
10. Place one hand around the front of the combined cards and the other hand under it to support it. Slide
the combined cards completely out of the chassis.
CAUTION:
back end. Be prepared to accept the full weight—up to 25 lb (11.34 kg)—as you
slide the cards out of the chassis.
When the combined cards are out of the chassis, do not hold the cards by the
ejector handles, bus bars, or edge connectors. They cannot support the card's
weight.
Do not stack the combined cards on top of one another after removal.
Do not leave a fiber-optic transceiver uncovered except when inserting
Avoid bending fiber-optic cable beyond its minimum bend radius. An
The weight of the MPC with the adapter card is concentrated in the
391
Advertisement
Table of Contents
