Table of Contents
Advertisement
SEE ALSO
MX2008 Craft Interface Description | 43
MX2008 Alarm Relay Contacts on the Craft Interface | 45
MX2008 Cable Manager Description
IN THIS SECTION
Standard Cable Manager | 50
Extended Cable Manager | 52
The MX2008 router supports the following cable managers:
NOTE:
The MX2008, MX2010, and MX2020 routers support the same cable managers.
Standard Cable Manager
The standard cable manager consists of the following components:
Card-cage cable manager—MX2000-CBL-MID
Lower cable manager—MX2000-CBL-BTM-S
DC power cable manager—MX2000-DC-CBL-MGR-S
The lower cable manager (see
removable cover that is secured by two captive screws with access to rows used for routing and securing
the cables away from the front of the Modular Port Concentrators (MPCs) and Modular Interface Cards
(MICs) (see
Figure 12 on page
You can use cable strips or other ties to gently secure the cables in the lower cable manager. To secure
the cables in place, loop the tie through the cable anchor and secure the tie.
Each DC PDM has one cable manager. The DC cable manager routes cables away from the rear of the
PDMs (see
Figure 11 on page
Figure 11 on page
51) is located just below the lower card cage, has a
51).
51).
50
Advertisement
Table of Contents
