Table of Contents
Advertisement
Maintaining Switch Fabric Board
IN THIS SECTION
Replacing an MX2008 SFB | 406
Replacing an MX2008 SFB
IN THIS SECTION
Removing an MX2008 SFB | 406
Installing an MX2008 SFB | 407
Removing an MX2008 SFB
To remove an MX2008 Switch Fabric Board (SFB) (see
NOTE:
You can remove the SFB as a unit.
CAUTION:
handles properly to avoid damage to the equipment.
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
3. Open the ejector handle outward to unseat the SFB.
Before removing an SFB, ensure that you know how to operate the ejector
Figure 174 on page
407):
406
Advertisement
Table of Contents
