Table of Contents
Advertisement
Removing an MX2008 Fan Tray
CAUTION:
removing the existing fan tray.
To remove the lower fan trays (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Reposition the DC cable manager, if necessary, before removing the lower fan tray:
Unwrap any cables on the DC cable manager, and remove the cables from the tray. Arrange the
cables so that they do not block the front of the cable manager and tray, and secure them with
temporary fasteners so that they are not supporting their own weight as they hang from the connector.
3. Loosen the two captive screws on each side of the fan tray access panel and open.
4. Loosen the two captive screws on the fan tray faceplate.
5. While grasping the handle, press and hold the latch until the status LED turns off. Pull the fan tray out
approximately 1 to 3 inches until it stops.
NOTE:
The fan trays are interchangeable and are hot-insertable and hot-removable.
6. Press and hold the latch a second time to disengage fan operation. Place one hand under the fan tray
for support while pulling the fan tray completely out of the router.
WARNING:
press and hold the latch while removing the fan trays.
7. Place the fan tray on an antistatic mat or in an approved ESD bag.
WARNING:
completely.
To prevent overheating, install the replacement fan tray immediately after
Figure 162 on page
The fan trays use a double latch safety mechanism. You must continually
Before removing a fan tray, make sure the fan blades have stopped
376):
375
Advertisement
Table of Contents
